This product is a high data rate parallel active optical cable (AOC), to overcome the bandwidth limitation of traditional copper cable. The AOC is terminated with a QSFP28 module at one end and four SFP28 modules at the other. With the QSFP28 terminal, it offers 4 independent data transmission channels and 4 data receiving channels via multimode ribbon fibers, each capable of 25Gb/s operation.

This product is a high data rate parallel active optical cable (AOC), to overcome the bandwidth limitation of traditional copper cable. This product converts the parallel electrical input signals into parallel optical signals (light), by a driven Vertical Cavity Surface Emitting Laser (VCSEL) array. The light propagates through the ribbon fiber individually, and be captured by the photo diode array. The optical signals are converted into parallel electrical signals and outputted. Consequently, each terminal of the cable has 8 ports, 4 for data transmission and 4 for data receiving, to provide totally 100Gb/s data exchange.

QSFP+ Active Optic Cables are a high performance, low power consumption, long reach interconnect solution supporting 40G Ethernet, fiber channel and PCIe. It is compliant with the QSFP+ MSA and IEEE P802.3ba 40GBASE-SR4. Flyin QSFP+ AOC is an assembly of 4 full-duplex lanes, where each lane is capable of transmitting data at rates up to 10Gb/s, providing an aggregated rate of 40Gb/s. These AOCs can be used as an alternative solution to QSFP+ passive and active copper cables, while providing improved signal integrity, longer distances, superior electromagnetic immunity and better bit error rate performance.

SFP28 Active Optical Cable (AOC) assemblies use active circuits to support longer distances than standard Passive or Active SFP28 Copper Cables. They are designed for high speed, short range data link via optical fiber wire. SFP28 AOC cables provide high performance Enhanced Small Form Factor Pluggable (SFP28) interface and it is a cost effective solution for Data Center/ storage and all short range data application.

SFP+ Active Optical Cable (AOC) assemblies use active circuits to support longer distances than standard Passive or Active SFP+ Copper Cables. They are designed for high speed, short range data link via optical fiber wire. SFP+ AOC cables provide high performance Enhanced Small Form Factor Pluggable (SFP+) interface and it is a cost effective solution for Data Center/ storage and all short range data application.

400G 10km Transceiver Module supports link lengths of up to 10km over a standard pair of G.652 single mode fiber (SMF) with duplex LC connectors. The module offers high-speed, and low-power in 400G links.

hot-pluggable QSFP-DD transceiver for 400G links over multimode fiber. It is a high performance module for short-range data communication and interconnect application. This module is designed to operate over multimode fiber systems using a nominal wavelength of 850nm.

100G transceiver module portfolio offers a wide variety of high-density and low-power 100G connectivity options for data center, enterprise and telecom application. It includes 100G QSFP28 modules, 100G CFP/CFP2/CFP4 modules, 100G DACs/AOCs and their breakout cables. Featured products such as 100G and OTU4 QSFP28 Dual Rate Modules and 100G QSFP28 Single Lambda modules are also available for choice.

100G DWDM PAM4 transceiver supports to multiple 100G links up to 80km using TDCM and EDFA over single-mode fiber (SMF) via an CS connector.

100G DWDM PAM4 transceiver supports to multiple 100G links up to 80km using TDCM and EDFA over single-mode fiber (SMF) via an CS connector.